Page 1 of 1
Saber Cycle had Felt Shaft Seals Made for Us
Posted: Tue Jun 15, 2021 12:26 pm
by cfairweather
I just installed a couple of the felt shaft rings in a set of GL1000 carbs and I am happy to report they fit just right. I got these from Saber Cycle after I asked Diane if she could have some made to support the GL1000 community. I was impressed that she came through on my request. I know this cost her a bundle because I checked into having some made myself and the minimum order was several thousand dollars. She is selling these for less than half of what another place sells these. I don't work for Saber Cycle.
Re: Saber Cycle had Felt Shaft Seals Made for Us
Posted: Tue Jun 15, 2021 12:41 pm
by Oldewing
Pretty much the first GOOD thing I have heard about this company....
Re: Saber Cycle had Felt Shaft Seals Made for Us
Posted: Tue Jun 15, 2021 5:56 pm
by CYBORG
Oldewing wrote: ↑Tue Jun 15, 2021 12:41 pm
Pretty much the first GOOD thing I have heard about this company....
me too. Maybe things have changed
Re: Saber Cycle had Felt Shaft Seals Made for Us
Posted: Tue Jun 15, 2021 8:06 pm
by MikeNTexas
I have only been buying from them for the last 6 months and have had only good experiences.
Re: Saber Cycle had Felt Shaft Seals Made for Us
Posted: Tue Jun 15, 2021 8:46 pm
by Rat
There have been some positive reports lately ... let’s hope things have changed
Gord
Re: Saber Cycle had Felt Shaft Seals Made for Us
Posted: Tue Jun 15, 2021 9:00 pm
by Whiskerfish
Diane Contacted us probably 6 or 8 years ago and stated that she had been really concentrating on improving their Customer Service. Don't think I have heard from her since but good to see some positive reviews.
But note I still have serious reservations about their in house manufacturing sold under the Barracuda banner. Not recently but in the past I have seen some of those products and they were very typical substandard Chinese crap. I do not know if any of that has been improved. Proceed with caution.