Page 2 of 2
Re: cx drive shaft
Posted: Sun Jun 15, 2014 10:06 pm
by duke182
Very nice bike.
Re: cx drive shaft
Posted: Wed Aug 16, 2017 6:14 pm
by dbanta
who was the guy you sent this off to get modified? would you share?
puffy75 wrote:IMG_1952.JPG
Ok I know it has been awhile but it had a long way to go back and forth. The modified piece is below the left over pieces above from the two shafts. The longer forward portion is from the CX500 and the longer rear portion is from the GL500. Needed to fit the GL Pro Link rear swing arm to the CX along with other mods. IE: The pivot bearings are a different size and need modification, the mount for the single shock (I decided on duals) and the mounts for lower Pro Arm link. Still has to be road tested
Re: cx drive shaft
Posted: Wed Aug 16, 2017 6:21 pm
by Sagebrush
This is a pretty old thread and you may not get an answer as I haven't seen puffy75 post on this board for a long time.
Re: cx drive shaft
Posted: Wed Aug 16, 2017 11:28 pm
by dbanta
Hey thanks for letting me know he hasn't been around. I will try reaching him by e-mail. Here is what I am working on. Trying to get the drive shaft made. Swing arm in the back with a bearing supported shaft between the motor and the swing arm.
$_3.JPG
Re: cx drive shaft
Posted: Sat Aug 19, 2017 5:41 pm
by scootsx2
dbanta wrote:Hey thanks for letting me know he hasn't been around. I will try reaching him by e-mail. Here is what I am working on. Trying to get the drive shaft made. Swing arm in the back with a bearing supported shaft between the motor and the swing arm.
Nice project. You might also try over on the CX500 forum.